Researchers from the Institute of Metal Research of the Chinese Academy of Sciences have proposed a new way to design materials for cathodes (positive electrodes) of lithium-ion batteries. Instead of the usual trial-and-error selection of additives, they moved to targeted selection using physicochemical descriptors - measurable characteristics that can be used to predict a material's behavior. The work was published in the journal Nature Synthesis.

Battery capacity, charging speed, service life and safety depend on the properties of oxide cathodes. Adding trace amounts of other elements (doping) has long been used to modify the crystal lattice, lithium-ion conductivity and cycling stability. But the choice of additives long remained a matter of experience and repeated testing: there were not enough quantitative guidelines linking an additive's properties to the lattice structure and electrochemical performance.

The problem is especially acute for cobalt-free cathodes with a high nickel content. Eliminating cobalt reduces cost and increases capacity, but at the same time slows lithium-ion transport, increases lattice distortions, makes the oxygen framework less stable and accelerates electrochemical degradation.

A group led by Professors Li Feng, Cheng Huiming and Wang Chunyang proposed a descriptor-based multicomponent doping strategy. They identified two key parameters - ionic charge density and metal-oxygen bond strength - which link an additive's properties to lithium-ion transport and structural stability.

Under this scheme, elements with low ionic charge density (magnesium and calcium) were introduced into the material to weaken the electrostatic retention of lithium ions, and elements with strong metal-oxygen bonds (titanium and zirconium) to strengthen the oxygen sublattice and the transition-metal-oxygen framework.

The resulting cobalt-free nickel-rich cathode (MD-LNMO) showed improvement in both operating speed and structural stability at once. Its specific capacity was 130.9 mAh/g at a current of 25 C (C is the charge-discharge rate: 1 C means a full cycle in an hour, 25 C in 1/25 of an hour). After 350 cycles at 10 C, 82.4% of capacity was retained. At -20 C and a current of 1 C, the material delivered 112 mAh/g. In a prismatic cell (pouch cell) with a capacity of 5.74 Ah, the energy density at -20 C reached 278.6 Wh/kg.

Comprehensive measurements confirmed that the descriptor-based design simultaneously accelerates lithium-ion transport, suppresses undesirable phase transformations and mitigates electrochemical wear. The authors describe the work as a new methodology for creating cathodes with high energy density, long service life and fast charging. At the same time, these are laboratory samples, not finished commercial batteries.

Source: Tech Xplore