Multilayer chips, where dies are stacked one above another, can extend the growth of computing power but create a overheating problem: heat accumulates between the layers and flows from hot computing units to neighboring components, such as memory. To avoid this, materials are needed that act as a heat sink in one direction and as a thermal insulator in the other.

Researchers from the Institute of Industrial Science at the University of Tokyo and their colleagues proposed a method of "flipping engineering" - a way to design layered materials that conduct heat well along the layers and strongly block its flow between them. The work was published in the journal ACS Nano.

The approach is based on so-called Janus layers (two-faced atomic layers), whose top and bottom surfaces consist of different atoms. Thanks to this, each layer can be placed "face up" or "face down," as in the game "Tetris." The result is a simple programmable switch for controlling the structure.

The team studied MoSSe - a molybdenum-based material where one side of the layer contains sulfur atoms and the other contains selenium. A stack of 14 layers allows 8192 different flip sequences, which is too many for direct brute-force search. Instead, the scientists built a machine-learning-based workflow that combines prediction of heat transfer with optimization of layer stacking.

After checking only about 3% of the possible configurations, the researchers found a structure whose thermal conductivity along the layers is about 760 times the effective thermal conductivity across the layers at room temperature. This thermal anisotropy figure - the difference in properties in different directions - is about 35% higher than that of an ordered crystalline stack of the same thickness.

According to senior author Masahiro Nomura, the irregular sequence of flips disrupts the vibrations that transfer heat between layers but hardly affects the vibrations responsible for heat transfer along the layers. This makes it possible to selectively suppress the transverse heat flow while preserving conductivity in the plane of the layers.

The authors emphasize that fabrication and experimental verification of such structures are a task for the future. However, existing methods of layer-by-layer assembly, including those that allow individual layers to be flipped, offer a possible path to creating such materials. The results offer a new design principle that could help improve heat removal in three-dimensional semiconductor chips.

Source: Phys.org