Quantum light sources that emit single photons - particles of light - are needed for quantum communication, computing and ultrasensitive sensors. A promising material for such devices is a monolayer of tungsten diselenide (WSe2), a two-dimensional semiconductor one atomic layer thick. It can glow with narrow spectral lines, that is, emit photons with similar energies.
However, the excitation method hinders embedding such a source into a chip. A conventional laser illuminates many local states at once, and several peaks appear in the spectrum. In addition, an external laser complicates integration. Electrical excitation is more convenient, but existing devices require precise stacking of several two-dimensional layers, which is technologically difficult and reduces the yield of usable devices.
An international team led by Professor Yutaka Majima of the Institute of Science Tokyo (Japan) and Professor Ali Javey of the University of California (USA) proposed a nanogap platform. The study was published in the journal Nano Letters. The scientists combined a WSe2 monolayer with gold-platinum electrodes grown on a substrate, with a gap of less than 5 nanometers left between them. The electrodes were made by electron-beam lithography and chemical gold deposition, and the two-dimensional material was transferred onto the finished structure.
When a square-wave voltage at a frequency of 10 megahertz was applied to the silicon gate and the electrodes were grounded, the researchers observed electroluminescence at a temperature of 3.5 kelvin - slightly above absolute zero. The linewidth in the spectrum was 1.83 millielectronvolts. For comparison: under optical excitation, the same device produced a broad spectrum with many peaks. According to the authors, electrical excitation through the nanogap engages only a small fraction of the local states near the contact.
Computer modeling and structural analysis showed that the curved electrodes create nonuniform lattice strain in the monolayer, and the electric field is enhanced at the contact edges. Both factors may promote selective excitation. In addition, the sharp voltage swings in the square-wave signal apparently affect the injection and recombination of charge carriers.
Reproducibility was tested on 49 devices: 15 of them showed a narrow electroluminescence line. Control experiments with wider gaps and insulating spacers confirmed that what matters is precisely the small gap geometry, the enhanced local field and fast voltage switching.
The authors emphasize: the results demonstrate a new platform for electrically controlled narrow-band emission in two-dimensional materials. The flat, scalable architecture could be useful for creating nanoscale quantum light sources suitable for integration into chips. At the same time, practical devices are still far off: the measurements were performed at cryogenic temperature, and the share of working samples was less than one third.