Engineers at the University of California, San Diego (UC San Diego) have presented a robot made entirely of soft materials. It is capable of reaching a speed of up to 4.72 meters per second - slightly more than five yards. The six-legged device moves over sand, wood chips, concrete and other surfaces, and can swim and walk underwater. The robot is 3D-printed in its entirety, from a single material, and contains no electronics. The work is described in the journal Science Robotics.

The previous version, created in 2022, moved at only 4 centimeters per second. Its speed was limited by the pressure and airflow it could withstand. The new development, led by postdoc Yichen Zhai and Professor Michael T. Tolley of the Bioinspired Robotics and Design Lab, overcame this barrier by more than 100 times.

There is no electronics inside the robot - only interconnected chambers, valves and tubes. When compressed air passes through them, they set the legs in motion. To increase speed, the pressure must be raised and the airflow accelerated. To do this, the researchers made the robot and its internal structures larger and stronger. However, at too high a pressure the device begins to operate inefficiently: it releases air that still contains a lot of energy.

The solution was suggested by the design of a double-expansion steam engine, in which steam expands sequentially in several chambers. The engineers built into the robot a system of chambers and valves that forces compressed air to circulate twice: first in small high-pressure chambers that control the valves, then in large low-pressure chambers that drive the legs. As a result, the robot became more than 100 times faster than the first version.

"Our first walking robot showed that this was possible, but it was too slow. We hoped to overcome this limitation and found a solution that made the new robot 100 times faster," a press release quotes Zhai as saying.

The tests took place on concrete, gravel, lawn, wood chips and sand. The robot descended a staircase, swam and worked underwater. For now it can function only while connected to a compressed air source, such as a compressor. In the future the authors plan to reduce air consumption so that the robot can operate autonomously with a portable source - for example, a compressed air cartridge. They also want to teach it to turn and manipulate objects.

According to the researchers, such 3D-printed robots without electronics could be useful where electronic devices do not work: in areas with high radiation or strong magnetic fields, in disaster relief and in space.

Source: Tech Xplore