Engineers from the Korea Advanced Institute of Science and Technology (KAIST) have developed an electrode that can be embedded in curved structures. The work was published in the journal Advanced Composites and Hybrid Materials. In the future, such electrodes could make drone legs or robot frames serve simultaneously as support and power source.

Usually the battery and the device body are separate parts. This increases weight and takes up space. Structural batteries combine both functions: the element bears load and stores energy. But to embed a battery in a curved part, an electrode resistant to deformation is needed.

The team of Professor Il Kwon Oh from the Department of Mechanical Engineering chose a lithium-sulfur battery. In it, the cathode - one of the two electrodes - is made on a sulfur basis. Such batteries can store a lot of energy at low weight, but sulfur has low electrical conductivity, and intermediate compounds - lithium polysulfides - can dissolve and migrate away from the electrode, degrading performance.

In addition, active materials are usually applied to a substrate as a coating. Under repeated bending it can peel off and disrupt electrical contact. To avoid this, the researchers grew nanowires of nickel cobalt selenide on the surface of carbon fabric. Nanowires are structures with a thickness in the nanometers, that is, billionths of a meter. The compound helps electrochemical reactions with sulfur and restrains the migration of polysulfides.

The nanowires are anchored directly on the carbon fibers rather than applied as a separate layer. In bending tests, the electrode withstood 1000 cycles with a radius of just 2.5 mm: the wires stayed in place and there was no visible damage. The electrode was then embedded in a lithium-sulfur soft battery in a pouch case and placed in oval, square and tubular structures, as well as in a drone leg part. In all cases it powered an LED.

Operation under load was also tested. In a cylindrical structure, the battery retained 99.8% of its initial voltage even under a load sufficient to destroy the surrounding frame. In another test, the LED burned without interruption or flicker.

The authors emphasize that this is a step toward structural batteries that go beyond flat shapes. The technology could be combined with composites - materials made of carbon fibers and resins - so that drone legs and robot frames simultaneously bear load and store energy. However, how much weight will be saved and how much flight time will increase remains to be determined.

Drones and robots contain many curved and hollow parts, so it is important that batteries work reliably inside such structures, Oh says. Our research shows that drone legs and robot frames can be not only support but also an energy storage system.

Source: Tech Xplore