At the former Hanford nuclear complex in Washington state, radioactive waste has accumulated for decades. It is stored in underground tanks connected by pipelines. The pipes were laid long ago, and their condition needs to be checked. Doing so is not easy: some sections are only 5.1 centimeters in diameter, the pipes are double-walled and have many right-angle bends.
Digging them up for visual inspection is expensive and unrealistic. Conventional "push" cameras advance only 3 meters at a time and cannot pass steep bends. Ultrasonic sensors for measuring wall thickness are often too bulky for narrow pipes. So specialists turned to the national laboratories.
A team from Sandia National Laboratories led by mechanical engineer Steve Buerger created the SPIINE robot (Self-Propelled Interior Inspector for Non-destructive-testing Examination). The device measures 5.1 by 15.2 centimeters. It has a flexible body, adaptive wheels, a steering system and a high-resolution camera with adjustable LED lighting. The motors allow it not only to move the robot itself but also to carry a payload, such as an ultrasonic or electromagnetic sensor for measuring pipe thickness. It is controlled with an ordinary game controller.
"Our first goal is simply to look inside the pipe," says engineer Daniel McArthur. "We want to detect corrosion, cracks and other damage that could be of concern."
The robot must overcome obstacles on the walls, liquid sludge and deposits, and travel hundreds of feet in a single run. To do this, SPIINE uses a single cable that carries power and data and withstands mechanical load. There is a provision for connecting several robots or drive modules in series. This helps counter the so-called capstan effect: the more bends the cable passes through, the harder it is to pull. If several robots pull the cable between bends, the resistance is reduced.
Work on the project has been under way for more than two years. During this time the robot has undergone several upgrades. Experiments were needed with elastic materials for the wheels to find the best grip on the pipe walls, and with power transmission from small motors. Laboratory tests at Sandia have now been successful, but a test at the real Hanford site lies ahead. New difficulties may emerge there. It is already known that a self-cleaning function for the lens and pipe walls will be needed, as well as a built-in emergency return system in case the robot gets stuck. In addition, researchers are studying the possibility of creating miniature ultrasonic sensors that will fit around a 90-degree bend.
"We are helping to keep the environment clean, and this mission is satisfying," says Buerger. According to him, work on such a device shows how small technology can be while remaining useful. An article about the development has been published in the journal Robotics.