As electric vehicles grow in popularity, scientists are looking for ways to make batteries more capacious, cheaper and more environmentally friendly. One promising material is aluminium. It can store a lot of lithium, and a sheet of aluminium foil can simultaneously serve as the battery's active material and as a conductor of electricity.

However, aluminium has a drawback: it degrades quickly during repeated charging and discharging. Researchers from Tohoku University and UACJ Corporation have found that a small addition of manganese slows this degradation. The work was published in the journal Communications Materials.

In conventional lithium-ion batteries, the anode (the electrode into which lithium ions enter during charging) is made by applying material to copper foil. Aluminium foil could simplify the design: it both stores lithium and conducts current, so copper current collectors, binders and energy-intensive coating processes are not needed. This would make batteries lighter, cheaper and more environmentally friendly.

The problem is that pure aluminium changes greatly when lithium enters it and comes back out. When lithium is removed, microscopic voids appear in the material, it becomes porous and loses strength. In addition, repeated reactions with the electrolyte (the liquid medium that carries ions) create films on the surface that interfere with operation.

An addition of silicon could prevent the destruction, but it leads to another difficulty: lithium gets stuck deep in the material and cannot be fully used. Therefore, improving the durability of the electrode without losing capacity was long unachievable.

The team's solution is to uniformly dissolve a little manganese, an element that interacts weakly with lithium, in the aluminium. Manganese atoms slow the movement of lithium through the aluminium, and the material acquires a fine network of internal boundaries. These boundaries serve as pathways for lithium, facilitating its movement. As a result, lithium is removed more completely, and the aluminium retains a dense and stable structure, which slows wear.

"Our research shows that the internal microstructure of the electrode can be spontaneously optimized during battery operation simply by adding a trace amount of an element with low affinity for lithium," says Yuki Nakata, an assistant professor at Tohoku University's Institute for Materials Research and a co-author of the work. "By using the material's own properties rather than relying on complex pre-built nanostructures, this approach offers a practical and inexpensive strategy for developing next-generation electrodes."

So far this is a laboratory result, and no timeline for such batteries appearing on sale has been reported.

Source: Tech Xplore