Researchers from Idaho State University, together with colleagues from several US universities, have developed inkjet printing inks that make it possible to create flexible energy storage devices. The work was published in the journal Communications Materials.
The material is based on transition metal dichalcogenides (TMDs). These are layered compounds in which a layer of metal atoms is sandwiched between layers of sulfur. Each layer is only a few atoms thick, so almost all the atoms are on the surface and can interact with ions. This property is important for supercapacitors, devices that store energy by collecting ions on the electrode surface and charge faster than conventional batteries.
The authors mixed niobium and tantalum, metals that stand next to each other in the periodic table, in equal proportions. The result was an alloy with the composition (Nb0.5Ta0.5)S2. According to the researchers, the properties of such a material do not simply average the characteristics of the starting substances: the ratio of the metals becomes a tuning tool, as alloying once did for bronze and steel.
To turn the alloy crystal into ink, it was first grown and then exfoliated into nanosheets using sound waves in a solvent, a method known as liquid-phase exfoliation. Of the four solvents tested, one produced the smallest and most uniform sheets without oxidation. However, this solvent boils at about 284 degrees Celsius, which is too hot for flexible plastics. It was replaced with a mixture of three other liquids: ethanol maintains the consistency needed for spraying, 2-butanol slows evaporation, and alpha-terpineol makes the film more uniform.
A separate problem is the so-called coffee-ring effect, when a droplet leaves a dark rim as it dries. The selected solvent mixture creates microflows inside the droplet that carry the material back toward the center, and the film dries evenly. The inks do not require polymer binders and dry at temperatures below 200 degrees Celsius, which is suitable for flexible substrates.
Using the resulting inks, the scientists printed patterns on paper, sapphire and polyimide, a flexible plastic often used in electronics. The minimum feature width was about 50 micrometers, roughly half the thickness of a human hair. The researchers then assembled supercapacitors by printing gold electrodes in the shape of interdigitated fingers and coating them with a layer of ink.
The best samples stored 11.05 millifarads per square centimeter and 184.2 farads per cubic centimeter, more than previously described printed TMD-based supercapacitors. The power density was 883.8 microwatts per square centimeter, meaning the devices could deliver energy quickly.
The most telling result was a direct comparison. Devices made from pure tantalum disulfide accumulated about ten times less charge than the alloy, while those made from niobium disulfide barely worked at all. The combination of the two metals produced a result that neither of them showed on its own.
A limitation remains: after 2,200 charge-discharge cycles, the devices retained about 60 percent of their capacity. The authors call improving durability a priority for further work.
According to the researchers, these are the first TMD ternary-alloy inks, to their knowledge, suitable for aerosol inkjet printing. They view the result not as a finished product but as a recipe: create a new layered material, exfoliate it carefully, select an ink for the printer and print the device. This approach builds on their previous work with inks based on MXenes, another class of two-dimensional materials, and could be extended to other alloys. In the future, this could mean miniature flexible power sources printed directly onto a sensor patch, a smart label or a wearable device.