Researchers from the University of California, San Diego (USA) have developed a new binder for lithium-ion batteries that contains no fluorine and dissolves in water. The results were published on October 9 in the journal Nature Communications. It is a joint project of Zheng Chen's laboratory and Toyota Research Institute of North America.

A binder is a glue that is mixed with electrode powders to form layers attached to thin metal foils inside a battery. Although the binder accounts for a small share by weight, battery manufacturing and recycling depend heavily on it.

Lithium-ion batteries typically use a fluorine-containing binder: it provides strong adhesion and electrode stability over repeated charge and discharge cycles. However, as the authors note, that same stability makes recycling difficult. The fluorine-containing binder must be dissolved in a toxic solvent, and after the electrodes are coated, the solvent must be evaporated in large drying ovens. Additional solvent purification steps increase cost, energy consumption and environmental burden. During recycling, such binders leave hard-to-remove residues that require high temperatures or aggressive chemicals to remove, leading to hazardous waste and contamination of the recovered materials.

The new material does not have these drawbacks. It is made from two inexpensive and widely used polymers: polyacrylic acid, which helps the mixture spread evenly and provides flexibility, and carboxymethyl cellulose - of plant origin, used in the food and paper industries - which provides strength and adhesiveness. The polymers are dissolved in water, then citric acid is added, which chemically binds them into a strong network. The result is a binder that matches traditional fluorine-containing counterparts in strength, flexibility, stability and adhesion.

In tests, batteries with the new binder showed the same initial performance as conventional lithium-ion ones, and after hundreds and thousands of charge-discharge cycles they retained capacity even longer. The material is compatible with different types of electrodes, including lithium iron phosphate (LFP) cathodes, high-nickel cathodes, graphite and silicon anodes.

Recycling is also simplified: instead of aggressive chemicals and high temperatures, it is enough to disassemble the battery and soak the electrodes in water. The binder dissolves, and the electrode coating separates cleanly from the metal foil without residue. The recovered materials are then restored and used for new batteries that perform no worse than those assembled from materials obtained from batteries with a traditional binder.

The authors note that this is a laboratory result, and the next step will be scaling up binder production for commercial use. They are also working on optimizing the material for different battery chemistries and plan commercialization in collaboration with industrial partners.

Source: Tech Xplore